Welding Services in Lebanon: Structural, Stainless, and Aluminum Work

Welding is a craft — two welders looking at the same job will produce very different results. The right process depends on the metal (steel, stainless, aluminum) and the application (structural, decorative, food-grade, pressure vessel).

Welding Processes

• Stick (SMAW): cheap, portable, ugly bead — for site repairs, structural, rough work.
• MIG (GMAW): fast, clean, common — for sheet metal, body, general fabrication.
• TIG (GTAW): precise, beautiful, slow — for stainless, aluminum, exposed welds.
• Flux core: outdoor-friendly, no gas — for site work in wind.

Common Lebanese Jobs

• Iron gates and railings (decorative + structural).
• Steel stairs and balconies — must be engineered for load.
• Stainless kitchen counters, washbasins, hoods — TIG only.
• Aluminum boats, motorcycle frames — TIG/MIG with argon.
• Pipe welding (gas, water, steam) — certified welders required by code.

When to Demand Certified Welders

• Pressure vessels, boilers, gas lines.
• Structural steel for buildings (engineer-stamped drawings).
• Food-grade stainless (HACCP audits will check).
• Lifting equipment (cranes, hoists).

Quality Checks

• Visual: even bead, no porosity, no undercut, no spatter on finish surfaces.
• Penetration test: dye penetrant for cracks.
• X-ray or ultrasonic for critical pipe joints (code projects).
• Galvanize or paint after welding for outdoor steel.